Remko RM Series Uživatelský manuál stáhnout pdf (Strana 10)

▲/▼ Buttons

The▼ button is used to reduce the target temperature, the ▲ button

increases it. In automatic mode the temperature can be increased

or decreased by 1°C. Temperature adjustment is not possible in

dehumidifying mode.

Cooling mode

The display extinguishes

after 1 min.

Automatic mode

MODE Button

Press the MODE button to switch between the operating modes. A total

of 4 modes are available:

1. Automatic Cooling or heating mode (not supported)

2. Cooling Mainly used in summer

3. Dehumidify Used in summer or winter

4. Heating mode not supported</F>

MODEMODEMODE

Automatic Cooling Dehumidify Heating (not supported)

In automatic mode, the controller automatically selects heating or cooling

mode after it is switched on. The control range is 22 °C to 26 °C. This

can be raised or lowered using the ▲/▼ buttons.

AUTOMATIC Mode

AUTOMATIC

MODE

In cooling mode the room air is cooled to the preset target temperature.

The desired room temperature is set in 1 °C steps using the ▲/▼ buttons.

If the room temperature reaches 0.5 °C above the set target temperature,

the indoor unit starts to cool the room air. If the actual temperature falls

approx. 1 °C below the set room temperature, the controller switches the

cooling off. In order to protect the compressor, the controller will only

switch the cooling back on after a holding period of 3 minutes.

COOLING Mode

COOLING

MODE

▼

▲

▼

▲

REMKO RM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Žádné komentáře

Remko RM Series Uživatelský manuál Strana 10